LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Except Hybrid) >> Power Back Door Main Switch >> Inspection

Power Back Door Main Switch: Inspection

  1. INSPECT POWER BACK DOOR MAIN SWITCH 
    1. Measure the resistance according to the value (s) in the table below.

    Standard resistance 

    RESISTANCE SPECIFICATION

    Tester Connection Switch Condition Specified Condition
    1-2 Free (OFF) 10 kΩ or higher
    1-2 Pushed (ON) Below 1 Ω

    If the result is not as specified, replace the switch.

    Fig 1: Inspecting Power Back Door Main Switch
    G05422035Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals