LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Except Hybrid) >> Power Back Door Closer Switch >> Inspection

Power Back Door Closer Switch: Inspection

  1. INSPECT POWER BACK DOOR CLOSER SWITCH 
    1. Measure the resistance according to the value (s) in the table below.

    Standard resistance 

    RESISTANCE SPECIFICATION

    Tester Connection Switch Condition Specified Condition
    1-2 Pushed (ON) Below 1 Ω
    1-2 Free (OFF) 10 kΩ or higher

    If the result is not as specified, replace the switch.

    Fig 1: Inspecting Power Back Door Closer Switch
    G05422041Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals