LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Except Hybrid) >> Back Door Opener Switch >> Inspection

Back Door Opener Switch: Inspection

  1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY 
    1. Check operation of the opener switch.
      1. Measure the resistance according to the value (s) in the table below.
      Fig 1: Checking Operation Of Opener Switch
      G05420098Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

      RESISTANCE SPECIFICATION

      Tester Connection Switch Position Specified Condition
      2-3 Back door opener switch not pushed (OFF) 10 kΩ or higher
      2-3 Back door opener switch pushed (ON) Below 1 Ω

      If the result is not specified, replace the back door opener switch assembly.

    2. Check operation of the lock switch (w/ Smart Key System).
      1. Measure the resistance according to the value (s) in the table below.

      Standard resistance 

      RESISTANCE SPECIFICATION

      Tester Connection Switch Position Specified Condition
      1-2 Back door lock switch not pushed (OFF) 10 kΩ or higher
      1-2 Back door lock switch pushed (ON) Below 1 Ω

      If the result is not specified, replace the back door opener switch assembly.

      Fig 2: Checking Operation Of Lock Switch (W/ Smart Key System)
      G06114252Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals