LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Tire & Wheel (Except Hybrid) >> Tire Pressure Warning Reset Switch >> Inspection

Tire Pressure Warning Reset Switch: Inspection

  1. INSPECT TIRE PRESSURE WARNING RESET SWITCH 
    1. Remove the tire pressure warning reset switch.
    2. Measure the resistance according to the value (s) in the table below.

    Standard resistance 

    STANDARD RESISTANCE SPECIFICATION

    Tester Connection Switch Condition Specified Condition
    D32-1 - D32-2 ON Below 1 Ω
    OFF 10 kΩ or higher

    If the result is not as specified, replace the tire pressure warning reset switch.

    Fig 1: Inspecting Tire Pressure Warning Reset Switch
    G05417602Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals