Roof Drip Side Finish Moulding: Removal

REMOVE ROOF DRIP SIDE FINISH MOULDING JOINT COVER (w/o Roof Rack)
1. Disengage the clip and claw, and remove the roof drip side finish moulding joint cover as shown in the illustration.
  HINT:
  
  Use the same procedure for the rear side and front side.
  
  Fig 1: Removing Roof Drip Side Finish Moulding Joint Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT ROOF RACK LEG COVER (w/ Roof Rack) (See REMOVAL )
REMOVE REAR ROOF RACK LEG COVER (w/ Roof Rack) (See REMOVAL )
REMOVE ROOF RACK ASSEMBLY (w/ Roof Rack) (See REMOVAL )
REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING
1. Place a matchmark on the vehicle body on the location indicated in the illustration.
2. Remove the center roof drip side finish moulding.
  
  Fig 2: Identifying Matchmark On Vehicle Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ROOF DRIP SIDE FINISH MOULDING (for Front Side)
1. Disengage the clip and remove the roof drip side finish moulding.
  
  Fig 3: Identifying Roof Drip Side Finish Moulding Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ROOF DRIP SIDE FINISH MOULDING (for Rear Side)
1. Disengage the clip and remove the roof drip side finish moulding.
  
  Fig 4: Identifying Roof Drip Side Finish Moulding Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CENTER ROOF RACK BRACKET (w/o Roof Rack)
1. Remove the 2 bolts and center roof rack bracket.
  HINT:
  
  Use the same procedure for the rear side and front side.
  
  Fig 5: Identifying Center Roof Rack Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002