Rear Bumper: Disassembly

1. Remove the nut and reflex reflector assembly LH.

HINT:

Use the same procedure for the RH side and LH side.

1. Remove the 2 clips.
   Fig 1: Identifying Reflex Reflector Assembly LH With Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disengage the 10 claws and 2 guides, and remove the lower rear bumper cover.
   Fig 2: Identifying Lower Rear Bumper Cover Claws And Guides

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disengage the 2 guides and remove the rear bumper energy absorber.
   Fig 3: Identifying Rear Bumper Energy Absorber Guides

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the rear bumper bar from the rear bumper energy absorber.
   Fig 4: Identifying Rear Bumper Bar

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disengage the 3 claws and remove the rear bumper plate LH.

HINT:

Use the same procedure for the RH side and LH side.

Fig 5: Identifying Claws On Rear Bumper Plate LH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 6 nuts and rear bumper reinforcement.
   Fig 6: Identifying Rear Bumper Reinforcement Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the screw.
2. Disengage the 2 claws and remove the rear bumper side retainer LH.

HINT:

Use the same procedures for the RH side and LH side.

Fig 7: Identifying Rear Bumper Side Retainer LH With Claws And Screw

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 screws.
2. Disengage the 3 claws and remove the No. 2 rear bumper side support LH.

HINT:

Use the same procedures for the RH side and LH side.

Fig 8: Identifying No. 2 Rear Bumper Side Support LH With Claws And Screws

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disengage the 2 claws and remove the No. 1 rear bumper side support.

   HINT:

   Use the same procedure for the RH side and LH side.

   Fig 9: Identifying Claws On No. 1 Rear Bumper Side Support

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002