FENDER LINER (for Rear Side): Removal

REMOVE REAR WHEEL HOUSE PAD LH
1. Remove the 3 screws and rear wheel house pad LH.
REMOVE REAR WHEEL HOUSE PAD RH
HINT:

Use the same procedure for the RH side and LH side.

REMOVE QUARTER PANEL SEAL LH

HINT:

When removing the quarter panel seal, heat the vehicle body and quarter panel seal using a heat light.

Fig 1: Identifying Rear Wheel House Pad Screws LH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Heating temperature

TEMPERATURE SPECIFICATION

Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)
Quarter Panel Seal	20 to 30°C (68 to 86°F)

NOTE: Do not heat the vehicle body or quarter panel seal excessively.

REMOVE QUARTER PANEL SEAL RH
HINT:

Use the same procedures for the RH side and LH side.

Fig 2: Peeling Off Double-Sided Tape
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR BUMPER SIDE SEAL LH
1. Remove the clip, screw and bolt.
2. Remove the 2 grommets.
  HINT:
  
  The grommets need to be replaced with new ones because they will break when they are removed.
3. Remove the rear bumper side seal LH.
  
  Fig 3: Identifying Rear Bumper Side Seal LH With Clip, Screw And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR BUMPER SIDE SEAL RH
HINT:

Use the same procedures for the RH side and LH side.
REMOVE REAR WHEEL HOUSE LINER LH
1. Remove the 10 clips and rear wheel house liner LH.
  
  Fig 4: Identifying Rear Wheel House Liner LH Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR WHEEL HOUSE LINER RH
1. Remove the 10 clips and rear wheel house liner RH.
  
  Fig 5: Identifying Rear Wheel House Liner RH Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002