LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation (Except Hybrid) >> Navigation Receiver >> Removal

Navigation Receiver: Removal

  1. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY  (See REMOVAL )
  2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Smart Key System)  (See REMOVAL )
  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Key System)  (See REMOVAL )
  4. REMOVE HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System)  (See AIR CONDITIONING PANEL (FOR MANUAL AIR CONDITIONING SYSTEM) )
  5. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)  (See REMOVAL )
  6. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET 
    1. Remove the 4 bolts.
      Fig 1: Locating Navigation Receiver Assembly With Bracket Bolts
      G05420927Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pull the navigation receiver assembly with bracket toward the rear of the vehicle and disengage the 4 clips.
    3. Disconnect each connector and remove the navigation receiver assembly with bracket.
    Fig 2: Identifying Navigation Receiver Assembly With Bracket Clips
    G05420928Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE NO. 1 RADIO BRACKET 
    1. Disengage the claw and disconnect the connector.
      Fig 3: Identifying Connector Claw
      G05420929Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 6 screws and No. 1 radio bracket.
    Fig 4: Locating No. 1 Radio Bracket Screws
    G05420930Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE NO. 2 RADIO BRACKET 
    1. Remove the 6 screws and No. 2 radio bracket.
  9. REMOVE NAVIGATION RECEIVER ASSEMBLY 
scientia non olet · About LEMON Manuals