LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio/Visual (Except Hybrid) >> Steering Pad Switch >> Removal

Steering Pad Switch: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. REMOVE LOWER NO. 3 STEERING WHEEL COVER  (See REMOVAL )
  3. REMOVE LOWER NO. 2 STEERING WHEEL COVER  (See REMOVAL )
  4. REMOVE STEERING PAD  (See REMOVAL )
  5. REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Microphone) 
    1. Disconnect the steering pad switch connector from the spiral cable.
    2. Remove the screw.
    3. Disengage the 2 pins and remove the steering pad switch.
      Fig 1: Identifying Steering Pad Switch Assembly Screw, Pin And Connector (W/ Microphone)
      G05420421Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the screw.
    5. Disengage the 2 pins and remove the steering pad switch assembly.
    Fig 2: Identifying Steering Pad Switch Assembly Pins And Screw
    G05420422Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE STEERING PAD SWITCH LH (w/o Microphone) 
    1. Disconnect the steering pad switch connector from the spiral cable.
    2. Remove the screw.
    3. Disengage the 2 pins and remove the steering pad switch LH.
    Fig 3: Identifying Steering Pad Switch LH Screw, Pins And Connector (W/O Microphone)
    G06121840Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals