Combination Meter: Installation

INSTALL COMBINATION METER ASSEMBLY
1. Connect the connector.
  
  Fig 1: Identifying Combination Meter Glass And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the combination meter assembly with the 4 screws.
  
  Fig 2: Locating Screws And Combination Meter Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
1. Engage the 4 claws and 4 clips, and install the instrument cluster finish panel assembly.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).

Fig 3: Identifying Instrument Cluster Finish Panel Assembly With Claws And Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002