Fuel Sender Gauge Assembly: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL FUEL SENDER GAUGE ASSEMBLY
1. Install the fuel sender gauge assembly by sliding it downward.
  NOTE: Make sure that the fuel sender gauge arm does not bend.
2. Connect the connector of the fuel sender gauge assembly.
NOTE: Do not damage the wire harness.

Fig 1: Installing Fuel Sender Gauge Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
1. Install the fuel suction tube assembly with pump and gauge to the fuel tank (See INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )
INSPECT FOR FUEL LEAK (See ON-VEHICLE INSPECTION )