LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla XLE, 1.8 L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Fuel System (2AZ-FE)) >> Fuel Pressure Pulsation Damper >> Removal

Fuel Pressure Pulsation Damper: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCHARGE FUEL SYSTEM PRESSURE  (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE  (See ON-VEHICLE INSPECTION )
  5. DISCONNECT FUEL MAIN TUBE  (See REMOVAL )
  6. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY 
    1. Remove the 2 bolts and fuel pressure pulsation damper.
    2. Remove the O-ring from the fuel pressure pulsation damper.
      Fig 1: Locating Fuel Pressure Pulsation Damper Bolts
      G04974912Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals