Fuel Pressure Pulsation Damper: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY
1. Apply a light coat of gasoline or spindle oil to a new O-ring and install it to the fuel pressure pulsation damper.
  
  Fig 1: Identifying Fuel Pressure Pulsation Damper Assembly O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the fuel pressure pulsation damper with the 2 bolts.
  
  Fig 2: Locating Fuel Pressure Pulsation Damper Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 9.0 N*m (90 kgf*cm, 80 in.*lbf)
  
  NOTE: Make sure that the O-ring is not cracked or does not jump out of position during installation.
INSTALL FUEL MAIN TUBE (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE (See INSTALLATION )
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )
INSPECT FOR FUEL LEAK (See ON-VEHICLE INSPECTION )