LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla XLE, 1.8 L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Starting System (2AZ-FE)) >> Relay >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT STARTER RELAY 
    1. Check the resistance.
      1. Using an ohmmeter, measure the resistance between the terminals.

      Standard Resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage is not applied to terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage is applied to terminals 1 and 2 Below 1 Ω
      Fig 1: Measuring Resistance Between Starter Relay Terminals
      G04942983Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, replace the relay.

  2. INSPECT ACC RELAY 
  1. Check the resistance.
    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard Resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage Is not applied to terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage Is applied to terminals 1 and 2 Below 1 Ω
      Fig 2: Measuring Resistance Between ACC Relay Terminals
      G04942983Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, replace the relay.

scientia non olet · About LEMON Manuals