Ignition Switch: Installation

1. INSTALL IGNITION SWITCH ASSEMBLY 
   1. Install the ignition switch with the 2 screws.
      Fig 1: Locating Ignition Switch Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Connect the connector.
      Fig 2: Locating Ignition Switch Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL UPPER STEERING COLUMN COVER  (See INSTALLATION )
3. INSTALL LOWER STEERING COLUMN COVER  (See INSTALLATION )
4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  (See INSTALLATION )
5. ADJUST SPIRAL CABLE  (See INSTALLATION )
6. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
7. INSTALL STEERING PAD  (See INSTALLATION )
8. INSTALL LOWER NO. 3 STEERING WHEEL COVER  (See DISPOSAL )
9. INSTALL LOWER NO. 2 STEERING WHEEL COVER  (See DISPOSAL )
10. INSPECT STEERING WHEEL CENTER POINT 
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    HINT:

    See INSTALLATION .

12. INSPECT STEERING PAD  (See DISPOSAL )
13. INSPECT SRS WARNING LIGHT 

HINT:

See DIAGNOSIS SYSTEM .