LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla XLE, 1.8 L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Emission Control System (2AZ-FE)) >> Purge Valve >> Removal

Purge Valve: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE VACUUM SWITCHING VALVE 
    1. Disconnect the vacuum switching valve connector.(A)
    2. Disconnect the wire harness clamp.(B)
    3. Disconnect the 2 purge line hoses from the vacuum switching valve.(C)
    4. Remove the vacuum switching valve.
      Fig 1: Locating Vacuum Switching Valve Connector, Wire Harness Clamp And Vacuum Switching Valve
      G06009136Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals