PCV Valve: Inspection

WARNING: This page is about a different variant/trim than selected.

INSPECT VENTILATION VALVE SUB-ASSEMBLY
1. Install a clean hose to the ventilation valve sub-assembly.
2. Inspect ventilation valve operation.
  1. Blow air into the cylinder head side, and check that air passes through easily.
    CAUTION: Do not suck air through the valve. Petroleum substances inside the valve are hazardous to your health.
    
    Fig 1: Blowing Air Into Cylinder Head Side For Checking Air Passes Through
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Blow air into the intake manifold side, and check that air passes through with difficulty. If the result is not as specified, replace the ventilation valve sub-assembly.
3. Remove the clean hose from the ventilation valve sub-assembly.
  
  Fig 2: Blowing Air Into Intake Manifold Side For Checking Air Passes
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002