Section 7 (Emission Control System (2AZ-FE)): Canister: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE CHARCOAL CANISTER ASSEMBLY
1. Disconnect the fuel tank vent hose from the charcoal canister assembly.
  
  Fig 1: Locating Fuel Tank Vent Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the vapor pressure sensor connector.
3. Disconnect the wire harness clamp.
4. Disconnect the purge line hose.
  
  Fig 2: Locating Vapor Pressure Sensor Connector, Wire Harness Clamp And Purge Line Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Disconnect the charcoal canister filter sub-assembly from the charcoal canister assembly.
  
  Fig 3: Identifying Charcoal Canister Filter Sub-Assembly And Charcoal Canister Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the 3 bolts and charcoal canister assembly.
  
  Fig 4: Locating Charcoal Canister Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002