Section 7 (Emission Control System (2AZ-FE)): Canister: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL CHARCOAL CANISTER ASSEMBLY
1. Install the charcoal canister assembly with the 3 bolts.
  Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
  
  Fig 1: Locating Charcoal Canister Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the charcoal canister filter sub-assembly to the charcoal canister assembly.
  
  Fig 2: Identifying Charcoal Canister Filter Sub-Assembly And Charcoal Canister Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the purge line hose.
4. Connect the wire harness clamp.
5. Connect the vapor pressure sensor connector.
  
  Fig 3: Locating Vapor Pressure Sensor Connector, Wire Harness Clamp And Purge Line Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Connect the fuel tank vent hose to the charcoal canister.
  
  Fig 4: Locating Fuel Tank Vent Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002