Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK LOOSENESS OF V-RIBBED BELT
1. Check the tension of the belt by pushing it down with a finger.
  OK:
  
  The tension of the belt is enough.
  
  NG: REPLACE V-RIBBED BELT TENSIONER ASSEMBLY (See CYLINDER HEAD GASKET )
  
  OK: Go to next step
CHECK V-RIBBED BELT FOR WEAR
1. Check the V-ribbed belt for wear.
  OK:
  
  The V-ribbed belt is not worn.
  
  NG: REPLACE V-RIBBED BELT (See GENERATOR )
  
  OK: Go to next step
CHECK CLUTCH PULLEY FOR WEAR
1. Check the clutch pulley groove for wear or other defects.
  OK:
  
  The clutch pulley groove is not damaged.
  
  NG: REPLACE CLUTCH PULLEY (See GENERATOR )
  
  OK: Go to next step
CHECK FOR NOISE WHILE CLUTCH PULLEY IS OPERATING
1. Perform a driving test and check if noise occurs when decelerating.
  OK:
  
  Noise does not occur.
  
  NG: REPLACE CLUTCH PULLEY (See GENERATOR )
  
  OK: REPLACE GENERATOR ASSEMBLY (See GENERATOR )