Oil Pressure Switch: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
1. Apply adhesive to 2 or 3 threads of the oil pressure switch.
  
  Fig 1: Applying Adhesive To Threads Of Oil Pressure Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Adhesive:
  
  Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
2. Using a 24 mm deep socket wrench, install the oil pressure switch.
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  
  NOTE: Do not start the engine for at least 1 hour after installation.
3. Connect the oil pressure switch connector.
INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE (See INSTALLATION )
INSPECT FOR OIL LEAK