Clutch Master Cylinder: Removal

WARNING: This page is about a different variant/trim than selected.

DISCONNECT CLUTCH RESERVOIR TUBE
1. Loosen the clip and disconnect the clutch reservoir tube from the clutch master cylinder assembly.
  NOTE: Wash off clutch fluid immediately if it comes in contact with any painted surface.
  
  HINT:
  
  Use a container to catch the fluid.
DISCONNECT CLUTCH LINE
1. Using a union nut wrench (10 mm), disconnect the clutch line.
  HINT:
  
  Use a container to catch the fluid.
  
  Fig 1: Disconnecting Clutch Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
1. Remove the clip and hole pin.
  
  Fig 2: Identifying Clip And Hole Pin
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 nuts and clutch master cylinder.
3. Remove the clutch master cylinder bracket.
  
  Fig 3: Locating Clutch Master Cylinder Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002