Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

READ OUTPUT DTC (DTC P0630)

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Read DTCs.

Result

DTC RESULT REFERENCE

Result	Proceed to
P0630	A
P0630 and other DTCs	B

If any DTCs other than P0630 are output, troubleshoot those DTCs first.

NOTE: If P0630 is set, the VIN must be input to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when inputting the VIN. If DTCs other than P0630 are set, check them first.

B: GO TO DTC CHART (See DIAGNOSTIC TROUBLE CODE CHART )

A: Go to next step

INPUT VIN
1. Input the VIN (See REGISTRATION ).
NEXT: END