Confirmation Driving Pattern

WARNING: This page is about a different variant/trim than selected.

HINT:

Performing this confirmation pattern will activate the mass air flow performance monitor.

Fig 1: Driving Pattern Of Vehicle Speed And Time

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTCs (See DTC CHECK / CLEAR ).
Start the engine, and warm it up until the engine coolant temperature reaches 70°C (158°F) or higher.
Drive the vehicle at approximately 62 mph (100 km/h) for 20 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes; then check if any DTCs (any pending DTCs) are set.