LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla XLE, 1.8 L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System (2AZ-FE) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection And Installation) >> Integration Relay >> Removal

Integration Relay: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE NO. 1 RELAY BLOCK COVER 
  2. REMOVE INTEGRATION RELAY 
    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and disconnect the integration relay.
      Fig 1: Removing Integration Relay
      G06007687Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the 3 connectors and remove the integration relay.
scientia non olet · About LEMON Manuals