LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla XLE, 1.8 L >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Engine Fuel System (2ZR-FE) >> Fuel Sender Gauge Assembly >> Removal

Fuel Sender Gauge Assembly: Removal

  1. DISCHARGE FUEL SYSTEM PRESSURE  (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  3. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE 
    1. Remove the fuel suction tube assembly with pump and gauge (See REMOVAL ).
  4. REMOVE FUEL SENDER GAUGE ASSEMBLY 
    1. Disconnect the fuel sender gauge connector.
      NOTE: Do not damage the wire harness.
    2. Release the lock and slide the fuel sender gauge assembly to remove it.
    NOTE: Make sure that the fuel sender gauge arm does not bend.
    Fig 1: Locating Fuel Sender Gauge Connector
    G06009823Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals