LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla XLE, 1.8 L >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (2ZR-FE) >> Front Crankshaft Oil Seal >> Installation

Front Crankshaft Oil Seal: Installation

  1. INSTALL TIMING CHAIN COVER OIL SEAL 
    1. Apply MP grease to the lip of a new oil seal.
      NOTE: Keep the lip free of foreign matter.
      Fig 1: Removing Timing Chain Cover Oil Seal
      G04974111Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

      SST 09223-22010 

      NOTE: Wipe off extra grease from the crankshaft.
  2. INSTALL CRANKSHAFT PULLEY 
    1. Align the pulley set key with the key groove of the pulley.
      Fig 2: Tapping Oil Seal
      G06008746Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using SST, hold the pulley in place and tighten the bolt.

      SST 09213-58013, 09330-00021 

      Torque: 190 N*m (1940 kgf*cm, 140 ft.*lbf) 

      NOTE: Check the SST installation positions when installing them to prevent the SST fixing bolts from coming into contact with the timing chain cover sub-assembly.
  3. INSTALL V-RIBBED BELT  (See INSTALLATION )
  4. ADJUST V-RIBBED BELT  (See INSTALLATION )
  5. INSPECT V-RIBBED BELT  (See ON-VEHICLE INSPECTION )
  6. ADD ENGINE OIL  (See INSPECTION )
  7. INSPECT FOR ENGINE OIL LEAK 
    Fig 3: Tightening Pulley Bolt
    G06008747Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. INSTALL NO. 2 CYLINDER HEAD COVER  (See step  85)
  9. INSTALL ENGINE UNDER COVER RH 
  10. INSTALL FRONT WHEEL RH 
scientia non olet · About LEMON Manuals