LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla XLE, 1.8 L >> Repair and Diagnosis >> Engine Mechanical >> Engine Lubrication System (2ZR-FE) >> Lubrication System >> On-Vehicle Inspection

On-Vehicle Inspection

  1. CHECK ENGINE OIL LEVEL 
    1. Warm up and stop the engine, then wait for 5 minutes.
    2. Check that the engine oil level is between the low level and full level marks on the level gauge. If low, check for engine oil leaks and add oil up to the full level mark.
      NOTE: Do not fill with engine oil to above the full level mark.
  2. CHECK ENGINE OIL QUALITY 
    1. Check the oil for deterioration, water, discoloring or thinning.

      If the quality is visibly poor, replace the oil.

  3. INSPECT OIL PRESSURE 
    1. Disconnect the oil pressure switch connector.
    2. Using a 24 mm deep socket wrench, remove the oil pressure switch.
      Fig 1: Removing Oil Pressure Switch
      G06009463Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the oil pressure gauge.
    4. Warm up the engine.
    5. Check the oil pressure.

      Oil Pressure 

      OIL PRESSURE SPECIFICATION

      At Idle At 3000 rpm
      25 kPa (0.3 kgf/cm2 , 3.6 psi) or more 150 to 400 kPa (1.5 to 4.1 kgf/cm2 , 22 to 58 psi)
    6. If the oil pressure is not as specified, check the oil pump (See INSPECTION ).
    7. Remove the oil pressure gauge.
    8. Apply adhesive to the end 2 or 3 threads on the oil pressure switch.
      Fig 2: Identifying Oil Pressure Gauge
      G06009464Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Adhesive: 

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent 

    9. Using a 24 mm deep socket wrench, install the oil pressure switch.

      Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

      NOTE: Do not start the engine for at least 1 hour after installation.
      Fig 3: Applying Adhesive To End 2 Or 3 Threads On Oil Pressure Switch
      G06009465Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    10. Connect the oil pressure switch connector.
    11. Check for engine oil leaks.