LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla XLE, 1.8 L >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Brake Master Cylinder >> Disassembly

Brake Master Cylinder: Disassembly

  1. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY 
    1. Remove the brake master cylinder reservoir filler cap assembly from the brake master cylinder reservoir assembly.
  2. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER 
    1. Remove the brake master cylinder reservoir strainer from the brake master cylinder reservoir assembly.
  3. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY 
    1. Mount the brake master cylinder sub-assembly in a vise.
      NOTE: Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.
    2. Using a pin punch and a hammer, tap out the straight pin and remove the brake master cylinder reservoir assembly.
  4. REMOVE MASTER CYLINDER RESERVOIR GROMMET 
    1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.
      Fig 1: Tapping Out Straight Pin
      G05389611Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals