LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla XLE, 1.8 L >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display >> Meter / Gauge System >> Entire Combination Meter does not Operate >> Inspection Procedure

Inspection Procedure

  1. INSPECT COMBINATION METER 
    1. Disconnect the E46 connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance 

      RESISTANCE REFERENCE

      Tester Connection Condition Specified Condition
      E46-30 (ET) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage 

      VOLTAGE SPECIFICATION

      Tester Connection Condition Specified Condition
      E46-32 (B) - Body ground Always 11 to 14 V
      E46-33 (IG+) - Body ground Ignition switch ON 11 to 14 V
      Fig 1: Identifying Combination Meter Connector Terminal
      G06014503Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

      OK: REPLACE COMBINATION METER  (See REMOVAL )

scientia non olet · About LEMON Manuals