LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Intake / Exhaust Assembly (2AZ-FE)) >> Exhaust Pipe And Catalytic Converter >> Removal

Exhaust Pipe And Catalytic Converter: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE TAIL EXHAUST PIPE ASSEMBLY 
    1. Remove the 2 bolts and 2 compression springs.
    2. Remove the tail exhaust pipe assembly from the 2 exhaust pipe supports.
    3. Remove the gasket from the center exhaust pipe assembly.
      Fig 1: Locating Bolts And Compression Springs
      G06009219Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE HEATED OXYGEN SENSOR  (See HEATED OXYGEN SENSOR )
  3. REMOVE CENTER EXHAUST PIPE ASSEMBLY 
    1. Remove the 2 bolts.
    2. Remove the center exhaust pipe assembly from the 2 exhaust pipe supports.
    3. Remove the gasket from the front exhaust pipe assembly.
      Fig 2: Locating Center Exhaust Pipe Assembly Bolts
      G06009220Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE FRONT EXHAUST PIPE ASSEMBLY 
    1. Remove the 2 bolts, 2 compression springs and front exhaust pipe assembly.
    2. Remove the gasket from the exhaust manifold.
      Fig 3: Locating Center Exhaust Pipe Assembly Bolts
      G06009199Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals