Fuel Sender Gauge Assembly: Inspection
WARNING: This page is about a different variant/trim than selected.
- INSPECT FUEL SENDER GAUGE ASSEMBLY
- Check that the float moves smoothly between F and E.
- Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below.
Standard Resistance
TERMINAL RESISTANCE CHART
| Float Level | Resistance (Ω) |
|---|---|
| F | 13.5 to 16.5 |
| Between E and F | 13.5 to 414.5 (Gradually changes) |
| E | 405.5 to 414.5 |
If the value is not as specified, replace the fuel sender gauge assembly.