Section 7 (Starting System (2AZ-FE)): Starter: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL STARTER ASSEMBLY (for Manual Transaxle)
1. Install the starter assembly, clutch accumulator bracket and wire harness clamp bracket with the 3 bolts.
  Torque: Bolt A
  
  37 N*m (377 kgf*cm, 27 ft.*lbf)
  
  Bolt B
  
  12 N*m (120 kgf*cm, 9 ft.*lbf)
  
  Fig 1: Locating Starter Assembly, Clutch Accumulator Bracket And Wire Harness Clamp Bracket With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the wire harness to terminal 30 and install the nut. Then, attach the terminal cap.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
3. Connect the terminal 50 connector to the starter assembly.
Fig 2: Locating Starter Assembly Wire Harness Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STARTER ASSEMBLY (for Automatic Transaxle)
1. Install the starter assembly and wire harness clamp bracket with the 2 bolts.
  Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
  
  Fig 3: Locating Bolts, Wire Harness Clamp Bracket And Starter Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the wire harness to terminal 30 and install the nut. Then, attach the terminal cap.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
  
  Fig 4: Locating Starter Assembly Wire Harness Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the terminal 50 connector to the starter assembly.
INSTALL BATTERY CARRIER (See INSTALLATION )
INSTALL BATTERY (See INSTALLATION )
INSTALL WIRE HARNESS
1. Install the claw and wire harness.
  
  Fig 5: Identifying Wire Harness And Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER CASE (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE (See INSTALLATION )
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

HINT:

See INSTALLATION .