LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Starting System (2AZ-FE)) >> Ignition Switch >> Removal

Ignition Switch: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See AIRBAG SYSTEM ).
  1. ALIGN FRONT WHEELS STRAIGHT AHEAD 
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  3. REMOVE LOWER NO. 3 STEERING WHEEL COVER  (See REMOVAL )
  4. REMOVE LOWER NO. 2 STEERING WHEEL COVER  (See REMOVAL )
  5. REMOVE STEERING PAD  (See REMOVAL )
  6. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL )
  7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  (See REMOVAL )
  8. REMOVE LOWER STEERING COLUMN COVER  (See REMOVAL )
  9. REMOVE UPPER STEERING COLUMN COVER  (See REMOVAL )
  10. REMOVE IGNITION SWITCH ASSEMBLY 
    1. Disconnect the connector from the ignition switch.
      Fig 1: Locating Ignition Switch Connector
      G06009587Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 screws and ignition switch.
      Fig 2: Locating Ignition Switch Screws
      G06009588Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals