LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Emission Control System (2AZ-FE)) >> Purge Valve >> Installation

Purge Valve: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL VACUUM SWITCHING VALVE 
    1. Install the vacuum switching valve onto the air cleaner hose.
    2. Connect the 2 purge line hoses to the vacuum switching valve.(A)
    3. Connect the wire harness clamp.(B)
    4. Connect the vacuum switching valve connector.(C)
      Fig 1: Locating Vacuum Switching Valve, Wire Harness Clamp And Vacuum Switching Valve Connector
      G06009140Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals