On-Vehicle Inspection
WARNING: This page is about a different variant/trim than selected.
- INSPECT COOLING FAN RELAY NO. 1
- Remove the relay from the engine room relay block.
- Measure the resistance of the relay.
Standard Resistance
STANDARD RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition 3-5 - 10 kΩ or higher 3-5 When battery voltage is applied to terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the relay.
- Install the relay.
- INSPECT COOLING FAN RELAY NO. 2
- Remove the relay from the engine room relay block.
- Measure the resistance of the relay.
Standard Resistance
STANDARD RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition 3-4 - Below 1 Ω 3-4 When battery voltage is applied to terminals 1 and 2 10 kΩ or higher 3-5 - 10 kΩ or higher 3-5 When battery voltage is applied to terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the relay.
- Install the relay.
- INSPECT COOLING FAN RELAY NO. 3
- Remove the relay from the engine room relay block.
- Measure the resistance of the relay.
Standard Resistance
STANDARD RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition 3-5 - 10 kΩ or higher 3-5 When battery voltage Is applied to terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the relay.
- Install the relay.