LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Cooling System (2AZ-FE)) >> Cooling Fan Motor >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT COOLING FAN MOTOR 
    1. Check that the motor operates smoothly when the battery is connected to the fan motor connector.

      If the motor does not operate smoothly, replace the cooling fan motor.

    2. Connect the pickup of a clamp-on ammeter over one of the two wires for the cooling fan motor.
    3. Measure the current while the motor is operating.

      Standard Current 

      CURRENT SPECIFICATION

      Connection Condition Specified Condition
      Fan wire 20°C (68°F) 7.4 to 11.4 A

      If the result is not as specified, replace the cooling fan motor.

      Fig 1: Identifying Cooling Fan Motor Connector
      G06009297Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT NO. 2 COOLING FAN MOTOR 
    1. Check that the motor operates smoothly when the battery is connected to the fan motor connector.
    2. Connect the pickup of a clamp-on ammeter over one of the two wires for the cooling fan motor.
    3. Measure the current while the motor is operating.

      Standard Current 

      CURRENT SPECIFICATION

      Connection Condition Specified Condition
      Fan wire 20°C (68°F) 4.7 to 8.7 A

      If the result is not as specified, replace the No. 2 cooling fan motor.

      Fig 2: Identifying No. 2 Cooling Fan Motor Connector
      G06009298Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals