Oil Pump: Reassembly

WARNING: This page is about a different variant/trim than selected.

INSTALL OIL PUMP COVER
1. Coat the drive rotor and driven rotor with engine oil.
2. Place the drive and driven rotors into the oil pump with the marks facing the pump cover side.
  
  Fig 1: Identifying Mark On Oil Pump Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the oil pump cover with the 5 bolts.
  Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf)
INSTALL OIL PUMP RELIEF VALVE
1. Coat the relief valve with engine oil.
  
  Fig 2: Identifying Bolts And Oil Pump Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Insert the relief valve and spring into the pump body hole.
3. Using a 27 mm socket wrench, install the plug.
  Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
  
  Fig 3: Identifying Valve Spring And Relief Valve
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL OIL PUMP STRAINER
1. Install a new gasket and the oil strainer with the 2 nuts.
  Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf)
  
  Fig 4: Identifying Nuts, Oil Pump Strainer And Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002