Front Crankshaft Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE FRONT WHEEL RH
REMOVE ENGINE UNDER COVER RH
REMOVE V-RIBBED BELT (See ON-VEHICLE INSPECTION )
REMOVE CRANKSHAFT PULLEY
1. Using SST, hold the crankshaft pulley in place and loosen the pulley bolt.
  SST 09213-54015 (91651 -60855), 09330-00021
  
  Fig 1: Holding Crankshaft Pulley Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, remove the crankshaft pulley.
  SST 09950-50013 (09951 -05010, 09952-05010, 09953-05020, 09954-05021), 09950-40011 (09957-04010)
  
  HINT:
  
  If necessary, remove the pulley and pulley bolt using SST.
  
  Fig 2: Removing Crankshaft Pulley
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT CRANKSHAFT OIL SEAL
1. Using a knife, cut off the lip of the oil seal.
2. Using a screwdriver, pry out the oil seal.
  NOTE: Do not damage the surfaces of the oil seal press fit hole and crankshaft.
  
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 3: Prying Out Oil Seal Using Screwdriver
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002