Throttle Body: Inspection
WARNING: This page is about a different variant/trim than selected.
- INSPECT THROTTLE BODY ASSEMBLY
- Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Standard Resistance
RESISTANCE REFERENCE
| Tester Connection |
Condition |
Specified Condition |
| 1 (M-) - 2 (M+) |
20°C (68°F) |
0.3 to 100 Ω |
If the result is not as specified, replace the throttle body assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002