Transmission Wire: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL TRANSMISSION WIRE
1. Coat a new O-ring with ATF and install it to the transmission wire.
  
  Fig 1: Locating O-Ring Of Transmission Wire
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pass the transmission wire through the transaxle.
  
  Fig 2: Identifying Transmission Wire
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the transmission wire with the bolt.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
INSTALL TRANSMISSION VALVE BODY ASSEMBLY (See INSTALLATION )
INSTALL VALVE BODY OIL STRAINER ASSEMBLY (See INSTALLATION )
INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY (See INSTALLATION )

Fig 3: Locating Transmission Wire Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADD AUTOMATIC TRANSAXLE FLUID
INSPECT TRANSAXLE FLUID LEVEL (See ON-VEHICLE INSPECTION )
INSTALL ENGINE UNDER COVER LH