LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Automatic Transmission - U341E) >> Shift Lever >> Reassembly

Shift Lever: Reassembly

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL SHIFT LOCK CONTROL ECU SUB-ASSEMBLY 
    1. Engage the 3 claws and install the shift lock control ECU sub-assembly to the shift lock control unit.
    2. Connect the shift lock solenoid connector to the shift lock control ECU sub-assembly.
  2. INSTALL POSITION INDICATOR LIGHT BULB 
    1. Install the cap to the bulb.
    2. Install the bulb to the position indicator light wire socket.
    Fig 1: Identifying Shift Lock Control ECU Sub-Assembly Connector And Claws
    G06011511Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY 
    1. Connect terminals 7 and 14 to the connector as shown in the illustration.
    2. Push in the stopper.
      Fig 2: Identifying Stopper And Connector Terminals
      G06011510Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the position indicator light wire socket and connector to the shift lock control unit.
    Fig 3: Installing Position Indicator Light Wire Socket And Connector
    G06011509Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL NO. 2 POSITION INDICATOR SLIDE COVER 
    1. Install the No. 2 position indicator slide cover to the position indicator slide cover.
    Fig 4: Identifying No. 2 Position Indicator Slide Cover
    G06011508Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL POSITION INDICATOR SLIDE COVER 
    1. Install the position indicator slide cover with the No. 2 position indicator slide cover to the shift lock control unit.
  6. INSTALL SHIFT LOCK RELEASE BUTTON COVER 
    1. Install the shift lock release button cover to the position indicator housing sub-assembly.
    Fig 5: Identifying Position Indicator Slide Cover
    G06011507Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY 
    1. Engage the 4 claws and install the floor shift position indicator housing sub-assembly to the shift lock control unit.
    NOTE: Make sure that the claws are firmly engaged.
    Fig 6: Identifying Floor Shift Position Indicator Housing Sub-Assembly Claws
    G06012155Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals