LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Automatic Transmission - U341E) >> Shift Lever >> Disassembly

Shift Lever: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY 
    1. Disengage the 4 claws and remove the position indicator housing sub-assembly from the shift lock control unit.
    NOTE: Do not damage the floor shift position indicator housing sub-assembly.
    Fig 1: Identifying Position Indicator Housing Sub-Assembly Claws
    G06012138Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE SHIFT LOCK RELEASE BUTTON COVER 
    1. Remove the shift lock release button cover from the position indicator housing sub-assembly.
  3. REMOVE POSITION INDICATOR SLIDE COVER 
    1. Remove the position indicator slide cover with the No. 2 position indicator slide cover from the shift lock control unit.
    Fig 2: Identifying Position Indicator Slide Cover
    G06011507Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE NO. 2 POSITION INDICATOR SLIDE COVER 
    1. Remove the No. 2 position indicator slide cover from the position indicator slide cover.
    Fig 3: Identifying No. 2 Position Indicator Slide Cover
    G06011508Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY 
    1. Separate the position indicator light wire socket and connector from the shift lock control unit.
      Fig 4: Separating Position Indicator Light Wire Socket And Connector
      G06011509Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, release the stopper.
    3. Using a screwdriver, disengage the locking lug of terminals 7 and 14, and pull the terminals out from the rear of the connector.
  6. REMOVE POSITION INDICATOR LIGHT BULB 
    1. Remove the bulb and cap from the indicator light wire socket.
    Fig 5: Identifying Stopper And Connector Terminals
    G06011510Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE SHIFT LOCK CONTROL ECU SUB-ASSEMBLY 
    1. Separate the connector from the shift lock control ECU sub-assembly.
    2. Disengage the 3 claws and the shift lock control ECU sub-assembly from the shift lock control unit.
    Fig 6: Identifying Shift Lock Control ECU Sub-Assembly Connector And Claws
    G06011511Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals