Park / Neutral Position Switch: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE ENGINE UNDER COVER LH
SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY
1. Remove the nut and disconnect the control cable assembly from the control shaft lever.
2. Remove the clip and disconnect the control cable assembly from the control cable bracket.
REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

Fig 1: Locating Transmission Control Cable Assembly Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the connector from the park/neutral position switch assembly.
2. Remove the nut, washer and control shaft lever.
  
  Fig 2: Locating Control Shaft Lever Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Pry out the lock plate and remove the manual valve shaft nut.
  
  Fig 3: Removing Manual Valve Shaft Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 2 bolts and pull out the park/neutral position switch assembly.