Oil Pump: Reassembly

WARNING: This page is about a different variant/trim than selected.

INSTALL CLUTCH DRUM OIL SEAL RING
1. Coat 2 new clutch drum oil seal rings with ATF, and install them to the stator shaft.
  
  Fig 1: Locating Clutch Drum Oil Seal Rings From Stator Shaft Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST and a hammer, install a new front oil pump oil seal to the oil pump body.
  SST 09950-60010 (09951-00550), 09950-70010 (09951-07100)
  
  Oil seal driven in depth:
  
  -0.15 to 0.15 mm (-0.00590 to 0.00590 in.)
Fig 2: Installing Front Oil Pump Oil Seal To Oil Pump Body Using SST And Hammer
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing upward.
Fig 3: Identifying Mark On Front Oil Pump Driven Gear
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing upward.
Fig 4: Identifying Mark On Front Oil Pump Drive Gear
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STATOR SHAFT ASSEMBLY
1. Using a "TORX" socket wrench T30, install the stator shaft assembly with the 10 "TORX" screws.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
  
  Fig 5: Identifying "TORX" Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT OIL PUMP ASSEMBLY
1. Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.
NOTE: Do not damage the oil seal lip.

Fig 6: Turning Drive Gear With Screwdrivers
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat a new front oil pump body O-ring with ATF, and install it to the oil pump.
Fig 7: Identifying Front Oil Pump Body O-Ring From Oil Pump
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002