LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Automatic Transmission - U341E) >> Oil Pump >> Disassembly

Oil Pump: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FRONT OIL PUMP BODY O-RING 
    1. Remove the front oil pump body O-ring from the oil pump.
    Fig 1: Identifying Front Oil Pump Body O-Ring From Oil Pump
    G04831453Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE STATOR SHAFT ASSEMBLY 
    1. Using a "TORX" socket wrench T30, remove the 10 "TORX" screws.
    Fig 2: Identifying "TORX" Screws
    G04831454Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FRONT OIL PUMP DRIVE GEAR 
    1. Remove the front oil pump drive gear from the oil pump body.
    Fig 3: Identifying Front Oil Pump Drive Gear From Oil Pump Body
    G04831455Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE FRONT OIL PUMP DRIVEN GEAR 
    1. Remove the front oil pump driven gear from the oil pump body.
    Fig 4: Identifying Front Oil Pump Driven Gear From Oil Pump Body
    G04831456Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE FRONT OIL PUMP OIL SEAL 
    1. Using SST, remove the front oil pump oil seal from the oil pump body.

      SST 09308-00010 

      Fig 5: Removing Front Oil Pump Oil Seal From Oil Pump Body Using SST
      G04831457Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE CLUTCH DRUM OIL SEAL RING 
    1. Using a screwdriver, remove the 2 clutch drum oil seal rings from the stator shaft assembly.
    Fig 6: Locating Clutch Drum Oil Seal Rings From Stator Shaft Assembly
    G04831458Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals