DTC P0787 Shift / Timing Solenoid Low (Shift Solenoid Valve ST); DTC P0788 Shift / Timing Solenoid High (Shift Solenoid Valve ST): Description
WARNING: This page is about a different variant/trim than selected.
Shift solenoid valve ST is switched ON-OFF by a signal from ECM so that let in or out timing of 2nd brake is adjusted by operating orifice control valve. Therefore, shift solenoid valve ST operates when letting in or out reverse clutch. If the shift solenoid valve ST is broken, the shift shock becomes big.
DTC DETECTION CONDITION CHART
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0787 | ECM detects short in solenoid valve ST circuit 2 times when solenoid valve ST is operated (1-trip detection logic) |
|
| P0788 | ECM detects open in solenoid valve ST circuit 2 times when solenoid valve ST is not operated (1 -trip detection logic) |
|