Valve Body Assembly: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL MANUAL VALVE
1. Install the manual valve to the valve body assembly.
  
  Fig 1: Identifying Shift Solenoid Valve SLT
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSMISSION VALVE BODY ASSEMBLY
1. Install the spring and check ball body.
  
  Fig 2: Identifying Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Align the groove of the manual valve with the pin of the lever.
3. Install the valve body with the 17 bolts.
  Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf)
  NOTE:
  - Push the valve body against the accumulator piston spring and the check ball body to install it.
  - First, temporarily tighten the bolts marked by (1) in the illustration because they are positioning bolts.
  Fig 3: Locating Bolts And Valve Body Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Bolt length:
  
  Bolt A: 25 mm (0.984 in.)
  
  Bolt B: 57 mm (2.24 in.)
  
  Bolt C: 41 mm (1.61 in.)
INSTALL VALVE BODY OIL STRAINER ASSEMBLY
1. Coat a new O-ring with ATF WS.
2. Install the O-ring to the oil strainer.
  
  Fig 4: Locating O-Ring From Oil Strainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the oil strainer with the 3 bolts.
  Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf)
  
  Fig 5: Locating Bolts And Oil Strainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSMISSION WIRE
1. Coat the O-ring with ATF WS.
2. Install the ATF temperature sensor with the lock plate and bolt.
  Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf)
3. Connect the 7 shift solenoid valve connectors.
INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY (See INSTALLATION )
INSTALL ENGINE UNDER COVER LH

Fig 6: Locating Shift Solenoid Valve Connectors
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADD AUTOMATIC TRANSAXLE FLUID
INSPECT TRANSAXLE FLUID LEVEL (See ON-VEHICLE INSPECTION )