LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - U250E) >> Transmission Wire >> Inspection

Transmission Wire: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT TRANSMISSION WIRE 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance 

      RESISTANCE SPECIFICATION

      Tester Connection ATF Temperature Specified Condition
      1 (THO) - 7 (E2) 10°C (50°F) 5 to 8 kΩ
      1 (THO) - 7 (E2) 25°C (77°F) 2.5 to 4.5 kΩ
      1 (THO) - 7 (E2) 110°C (230°F) 0.22 to 0.28 kΩ

      HINT:

      If the resistance is out of the specified range with the ATF temperature shown in the table above, the driveability of the vehicle may decrease.

      If the resistance value is not as specified, replace the transmission wire.

      Fig 1: Identifying THO And E2 Connector Terminals
      G06011444Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals