LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - U250E) >> Shift Lever >> Removal

Shift Lever: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH  (See REMOVAL )
  2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH  (See REMOVAL )
  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY  (See REMOVAL )
  5. REMOVE INSTRUMENT PANEL BOX ASSEMBLY  (See REMOVAL )
  6. REMOVE FRONT NO. 1 CONSOLE BOX INSERT  (See REMOVAL )
  7. REMOVE FRONT NO. 2 CONSOLE BOX INSERT  (See REMOVAL )
  8. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY  (See REMOVAL )
  9. REMOVE CONSOLE BOX CARPET  (See REMOVAL )
  10. REMOVE CONSOLE BOX ASSEMBLY  (See REMOVAL )
  11. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Move the shift lever to N.
    2. Disconnect the end of the transmission control cable assembly from the shift lever assembly.
      Fig 1: Disconnecting Transmission Control Cable Assembly
      G06011501Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using a screwdriver, pull out the stopper of the transmission control cable.
      NOTE: Do not remove the stopper. If the stopper is removed, reinstall it to its original position.
    4. Rotate the nut counterclockwise approximately 180°, and while holding the nut in place, disconnect the transmission control cable from the shift lever retainer.
      NOTE: Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.
      Fig 2: Pulling Out Stopper Of Transmission Control Cable
      G06011502Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE SHIFT LEVER ASSEMBLY 
    1. Disconnect the 2 connectors from the shift lever assembly.
      Fig 3: Disconnecting Connectors From Shift Lever Assembly
      G06011503Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Separate the 3 wire harness clamps from the shift lever assembly.
      Fig 4: Locating Wire Harness Clamps
      G06011504Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 bolts and shift lever assembly.
      Fig 5: Locating Bolts And Shift Lever Assembly
      G06011505Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals